Craft — Farost

Pupa — four colours and mounts

StFreon · September 2026

#StFreon#3d#pupa

A printable Pupa in four colours and a purple one, plus two pads for findings: a brooch pin and a cufflink. Blender scenes, a 3MF with the four coins and separate STLs.

colors — the four coloured coins; purple — the purple one; mounts — the pads for a pin and a cufflink.
The 3MF already carries the four coins; the STLs are for your own slicer; the Blender scenes are for editing.
The pin pad takes a 20 × 5 mm base, the cufflink pad a Ø10 mm disc.

files: 1222.9 MB

whole kitzip · 55.3 MB

Faropig — a printable figure, 78 mm

StFreon · September 2026

#StFreon#3d#faropig

A printable Faropig figure, 78 mm, with an eyelet at the back of the head for a chain. An STL, a PrusaSlicer project with supports, a Blender scene and the print settings.

The STL is for your own slicer; the 3MF is a ready PrusaSlicer project with supports; the blend is for editing.
Do not scale the model down: the hole for the chain shrinks with it.
The original Faropig design is by GOGA_BIBUBI (see the references).

files: 5125.9 MB

whole kitzip · 1.2 MB

Pupa pendant

miffril · August 2026photos

#miffril#3d#pupa

A printable Pupa in three cuts: sharp-edged, rounded, and with a hole for a chain. The Fusion source, an OBJ for Blender, STLs and a ready 3MF with print settings.

angled — a sharp edge; rounded — a rounded one; rounded-hole — rounded, with a hole for a chain.
The 3MF already carries the models and the print settings; the STLs are for your own slicer; the OBJ is for editing.

files: 72.9 MB